How To – Enable Wake On LAN using a Cisco router

Wake On LAN is an Ethernet standard that allows for a device to be powered on when receiving a specially crafted “magic packet”. The “magic packet” is a broadcast frame consisting of 6 bytes of 255 (FF FF FF FF FF FF) followed by sixteen repetitions of the 48-bit MAC address. Turned off computers receiving the broadcast don’t actually process the message up the protocol stack, they are just looking out for a matching 102-byte string.

Because of this we can use a UDP datagram to remotely wake up a computer from somewhere else on a routed network. Here’s how you can achieve this using Cisco IOS.

The first thing we need to do is setup a static NAT entry for the UDP port we wish to use (usually 7 or 9), so that our “magic packet” is forwarded from our external interface to the host we want to power on. In the below example the IP address of the system we’re going to wake up is and the external interface is ATM0.1:

ip nat inside source static udp 7 int ATM0.1 7

Next up we need to create an access-list that will contain the IP addresses of systems we’ll be sending the Wake On LAN message from:

access-list 10 permit host

Finally we need to enable “directed broadcasts”. This enables packets sent to the subnet broadcast address to be sent from hosts that are not part of that subnet. Again, in the below example our external interface is ATM0.1:

int ATM0.1
ip directed-broadcast 10

You’ll then need to enable Wake on LAN on the device itself. Once that’s done you can use online services or free applications to wake your device.

Published by

Dave Hope

Dave works in IT for a leading UK based retirement developer, in his spare time he enjoys tinkering with technology and rock climbing.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.